Winter is the quiet season for a pond. Plants are dormant, fish and frogs are resting near the bottom, and the less you disturb them the better. A few jobs between November and February will keep fish safe, stop leaves rotting in the water and give you a clearer pond in spring.
- Keep a small patch of the surface ice-free. Never smash the ice.
- Cut back dead foliage before winter and get fallen leaves out of the water, so they don't break down in the pond.
- Stop feeding fish once the water drops below about 5°C.
- Autumn and winter are the best time to plant up or redesign a pond. Avoid big jobs in spring, when frogs, toads and newts breed.
1. Keep a hole in the ice
When a pond freezes over, gases from rotting leaves and fish waste can't escape. A small ice-free patch lets them out. This matters most in a fish pond, but it helps wildlife ponds too.
- Float a ball on the surface before a hard frost. Lift it out to leave a hole.
- Use a floating pond heater or ice vent in fish ponds.
- If the pond is already frozen, stand a pan of hot water on the ice and let it melt a hole.
2. Cut back and clear leaves
Dead foliage and leaves that sink rot over winter and feed the algae that turn ponds green in spring. Cut back before winter and scoop out anything that lands in the water, or keep a leaf net over smaller ponds until the trees are bare.
- Remove yellowing water lily leaves at the base of the stalk.
- Cut dead marginal foliage back to just above the water line.
- Don't cut hollow-stemmed plants below the water line. Water can get into the stems and rot the crown.
- Plants that keep their leaves or stems through winter still need a tidy-up in spring. Cut them back in late February or March, before new growth starts.
- Leave some stems standing on one side of the pond. Insects shelter in them over winter. Cut these back in spring too.
3. Look after fish
- Fish slow right down in cold water and can't digest much. Below about 10°C, switch to a small amount of easily digested (wheatgerm-based) food. Below about 5°C, stop feeding altogether.
- Keep a pond thermometer in the water so you're not guessing.
- In very cold spells, turn off waterfalls and fountains and raise the pump off the bottom. This stops the coldest water being mixed down to where the fish are resting.
4. Pumps, filters and UV
- If you have fish, keep the filter running through winter so the good bacteria survive.
- A UV clarifier can be switched off over winter. Fit a new bulb in spring, as bulbs lose strength over a season.
- If you rinse filter sponges, use a bucket of pond water, not tap water. Tap water kills the bacteria that keep the water clear.
5. Plant and redesign now
Hardy pond plants are dormant now and most look dead above the water. That's normal. Check the crown: firm means dormant, soft and smelly means it has rotted. Tender floating plants such as water hyacinth and water lettuce won't survive a UK winter, so take them out before they rot.
Autumn and winter are the best time to add new plants or redesign your pond. Pond plants sit dormant, but many keep rooting through this period, so they're settled in by spring. Any mud and mess you stir up has time to settle before spring, when frogs, toads and newts come back to breed.
Work gently when you're in the pond. Some frogs and newts spend the winter in the mud at the bottom. If you find any, move them to a quiet, deep corner of the pond.
Month by month
| Month | Jobs |
|---|---|
| November | Net the pond or scoop leaves daily as they fall. Cut back dead foliage so it doesn't break down in the water. Take out tender floating plants. Reduce fish feeding. A good time to plant and redesign. |
| December | Keep an ice-free patch. Plant and redesign on mild days when the pond isn't frozen. |
| January | Check pond heaters and floats after hard frosts. Keep planting on mild days. |
| February | Finish planting and any redesign before frogs start to spawn. Cut back plants that kept their foliage over winter, before new shoots appear. Watch for the first frogspawn in mild spells. |
What you'll need
- A pond net or pond cleaning kit for leaves
- A pond vacuum if sludge builds up
- A floating ball, ice vent or pond heater
- A pond thermometer
Common mistakes
- Breaking ice with a hammer or spade. Melt a hole instead.
- Leaving big jobs until spring. Frogs, toads and newts breed from late February. Plant, redesign and clean out in autumn and winter instead.
- Feeding fish in cold water. Uneaten food rots and fouls the water.
- Cutting everything back to bare stumps. Leave some cover for wildlife.
- Leaving leaves in the water. They're the main cause of green water in spring.